All Issue

2019 Vol.10, Issue 4

General Article

Improving the moisture performance of hot mix glass asphalt by high-density polyethylene as an asphalt binder modifier
Hamid Behbahani1*
,
Gholam Hossein Hamedi2
,
Gilani Vahid Najafi Moghaddam3
,
Mohammad Nikookar4
1Professor, School of Civil Engineering, Iran University of Science and Technology (IUST), Tehran, Iran
2Assistant Professor, Department of Civil Engineering, University of Guilan, Rasht, Iran
3PhD student, School of Civil Engineering, Iran University of Science and Technology (IUST), Tehran, Iran
4Department of Civil Engineering, University of Guilan, Rasht, Iran
* Corresponding Author
31 December 2019. pp. 184-193
PDF XML Citation
Abstract

In this study, the waste plastic bottles have been used as a kind of known high-density polyethylene (HDPE) in order to modify the characteristics of asphalt binder in the hot mix glass asphalt (HMGA). The present glass asphalts have been constructed using 6, 12, 18 and 24% waste crushed glasses (WCG). To investigate the HDPE moisture susceptibility, Marshall Stability and Indirect Tensile Strength (ITS) tests were conducted on different combinations of HMGA. The results indicated that the combination of 18% WCG and 6% HDPE is the best value for the resistance of asphalt mixtures against moisture susceptibility. However, increasing the amount of HDPE more than 6%, reduces the performance of the asphalt binder and aggregate system against stripping. By increasing the amount of WCG, the Marshall resistance of all asphalt mixtures will be increased compared to the controlled ones. Although, the asphalt binder modification of the HMGA mixtures using HDPE, increases their Marshall resistance comparing to the controlled and unmodified HMGA samples, this increase will be up to 9% HDPE. And higher values will reduce the Marshall resistance.

Keywords
hot mix glass asphalt
waste crushed glass
high-density polyethylene
moisture susceptibility
indirect tensile strength
References
1
M.K. Pashaki, M. Nikookar, S.M. Mirmoa'zen, and M. Arabani, "Geomechanical properties of peat stabilized with cement and sand." International Journal of Advanced and Applied Sciences. 4(9) (2017), pp. 19-25.
10.21833/ijaas.2017.09.003
2
M. Nikookar, M. Arabani, S.M. Mirmoa'zen, and M. K. Pashaki, "Experimental Evaluation of the Strength of Peat Stabilized with Hydrated Lime." Periodica Polytechnica Civil Engineering 60(4) (2016), pp. 491-502.
10.3311/PPci.8159
3
M. Arezoumandi, A.R. Steele, and J.S. Volz, "Evaluation of the bond strengths between concrete and reinforcement as a function of recycled concrete aggregate replacement level." In Structures, Elsevier, 16 (2018) pp. 73-81.
10.1016/j.istruc.2018.08.012
4
S. Xu, N. Xie, X. Cheng, S. Huang, L. Feng, P. Hou, and Y. Zhu, "Environmental resistance of cement concrete modified with low dosage nano particles." Construction and Building Materials 164 (2018), pp. 535-553.
10.1016/j.conbuildmat.2017.12.188
5
S. Oruji, N.A. Brake, R.K. Guduru, L, Nalluri, Ö. Günaydın-Şen, K. Kharel, S. Rabbanifar, S. Hosseini, and E. Ingram, "Mitigation of ASR expansion in concrete using ultra-fine coal bottom ash." Construction and Building Materials 202 (2019), pp. 814-824.
10.1016/j.conbuildmat.2019.01.013
6
T.T.M. Nguyen, S. Rabbanifar, N.A. Brake, Q. Qian, K. Kibodeaux, E.H. Crochet, S. Oruji, R. Whitt, J. Farrow, B. belaire, P. Bernazzani, and M. Jao, "Stabilization of silty clayey dredged material." Journal of Materials in Civil Engineering 30(9) (2018), 04018199.
10.1061/(ASCE)MT.1943-5533.0002391
7
G. Pooria, and N. Ranjbar, "Clayey soil stabilization using geopolymer and Portland cement." Construction and Building Materials, 188 (2018), pp. 361-371.
10.1016/j.conbuildmat.2018.07.207
8
M. Nikookar, M.K. Pashaki, and M. A, Engineering properties of stabilized soil of gisoom forest area using cement-sand mixture. Advances in Civil and Environmental Engineering. 2(3) (2014), pp. 162-171.
9
S. Lyacia, R. Mitiche-Kettab, and Si Bachir. D, "Evaluation of the workability, Marshall Parameters, and the stiffness modulus of rubber modified bituminous concrete.", The International Journal of Sustainable Building Technology and Urban Development, 2019. pp. 43-55
10
M. Hasaninia and H. Farshad, "The characteristics of hot mixed asphalt modified by nanosilica." Petroleum Science and Technology 35(4) (2017), pp. 351-359.
10.1080/10916466.2016.1258412
11
K.A. Ghuzlan, A. Khalid, and S. Obadah, Ar'ar. "Performance of warm asphalt mixtures using Sasobit." Petroleum Science and Technology 34(14) (2016), pp. 1263-1271.
10.1080/10916466.2016.1190756
12
I. Bargegol, V.N.M. Gilani, R.V. Nezafat, and R.N.M. Gilani, "Comparison and Evaluation of Fatigue Behavior of Asphalt Concrete Mixtures Containing Different Recycled Additives." Computational Research Progress in Applied Science & Engineering (CRPASE) 1(1) (2015).
13
É. Lachance-Tremblay, D. Perraton, M, Vaillancourt, and H.D. Benedetto, "Degradation of asphalt mixtures with glass aggregates subjected to freeze-thaw cycles." Cold Regions Science and Technology 141 (2017), pp. 8-15.
10.1016/j.coldregions.2017.05.003
14
S. Priyansh, A. Tophel, and A.K. Swamy, "Properties of asphalt binder and asphalt concrete containing waste polyethylene." Petroleum Science and Technology 35(5) (2017), pp. 495-500.
10.1080/10916466.2016.1265559
15
A. Mahyar, S.A. Tahami, and M. Taghipoor, "Laboratory investigation of hot mix asphalt containing waste materials." Road Materials and Pavement Design 18(3) (2017), pp. 713-729.
10.1080/14680629.2016.1189349
16
G. Qinglin, L. Li, Y. Cheng, Y. Jiao, and C. Xu, "Laboratory evaluation on performance of diatomite and glass fiber compound modified asphalt mixture." Materials & Design (1980-2015) 66 (2015), pp. 51-59.
10.1016/j.matdes.2014.10.033
17
A. Ivica and S. Dimter, "Properties of hot mix asphalt with substituted waste glass." Materials and structures 49(1-2) (2016), pp. 249-259.
10.1617/s11527-014-0492-3
18
G. H. Shafabakhsh and Y. Sajed, "Investigation of dynamic behavior of hot mix asphalt containing waste materials; case study: Glass cullet." Case Studies in Construction Materials 1 (2014), pp. 96-103.
10.1016/j.cscm.2014.05.002
19
B. Alexandre T, É. Lachance-Tremblay, M. Vaillancourt, and D. Perraton, "Comparative study of the laboratory performance of hot mix asphalt with 10 percent glass aggregates." In 61st Annual Conference of the Canadian Technical Asphalt Association, Banff, Alberta, Canada, (2016), p. 16.
20
H.G. Hossein, A. Sahraei, and M.R. Esmaeeli, "Investigate the effect of using polymeric anti-stripping additives on moisture damage of hot mix asphalt." European Journal of Environmental and Civil Engineering (2018), pp. 1-14.
10.1080/19648189.2018.1517697
21
B. Nura, M. Napiah, and I. Kamaruddin, "Influence of nanosilica on moisture resistance of polymer modified bitumens." Petroleum Science and Technology 36(3) (2018), pp. 244-250.
10.1080/10916466.2017.1419480
22
H. Behbahani, G.H. Hamedi, and V.N.M. Gilani, Effects of asphalt binder modifying with Nano hydrated lime on moisture susceptibility of asphalt mixtures with thermodynamically concepts. Petroleum Science and Technology, (2019), Accepted paper (In press).
10.1080/10916466.2019.1702685
23
A. Behnam, M.J. Rajabbolookat, A. Abdi, and R. Salehfard. "Investigating the influence of using nano- composites on storage stability of modified bitumen and moisture damage of HMA." Petroleum Science and Technology 35(8) (2017), pp. 800-805.
10.1080/10916466.2017.1292292
24
A. Mahmoud and D. Nasr, "Performance properties of devulcanized waste PET modified asphalt mixtures." Petroleum Science and Technology 35(1) (2017), pp. 99-104.
10.1080/10916466.2016.1251457
Information
  • Publisher :Sustainable Building Research Center (ERC) Innovative Durable Building and Infrastructure Research Center
  • Publisher(Ko) :건설구조물 내구성혁신 연구센터
  • Journal Title :International Journal of Sustainable Building Technology and Urban Development
  • Volume : 10
  • No :4
  • Pages :184-193
  • Received Date : 2019-08-05
  • Accepted Date : 2019-11-21
  • DOI :https://doi.org/10.22712/susb.20190020
Journal Informaiton International Journal of Sustainable Building Technology and Urban Development International Journal of Sustainable Building Technology and Urban Development
Online Submission
  • scopus
  • NRF
  • KOFST
  • KISTI Current Status
  • KISTI Cited-by
  • crosscheck
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close